Changing your IP
Method 1 of 2 - Changing your Puclic IP
3.Connect with Different Device. IP addresses may be assigned based on the first device that’s connected to the modem. This first device is typically the router. To get a new address, try connecting your computer directly to your modem:
- Shut everything down. In order to clear the old settings from your modem, you will need to make sure that everything on your network is powered down entirely, and that your modem is disconnected from the router. There should be no lights showing on the modem. Make sure that your computer is shut down as well.
- Your computer will be connected directly to the internet without the added protection of a router, if only for a few minutes. Make sure that your antivirus is up to date before powering down your computer and continuing the process.
- Connect the modem to your computer via Ethernet. Plug the Internet port in the modem directly into your computer’s Ethernet port.
- Turn on the modem first. Let it power all the way on. This can take up to one minute.
- Turn on the computer. Let it boot all the way up and connect to the internet. As soon as you have a connection shut it down.
- Reconnect the router. Once your computer has been shut down, plug the internet port of the modem into the WAN port of the router. Your network settings should not be changed, but you may have a new public IP now.[1]
Method 2 of 2:- Changing your Provete IP
1. Renew your IP address in the command prompt. To open the command prompt, enter “cmd” into the Search field in the Start menu. In Windows 8, type “cmd” when on the Start screen.- Once the command prompt it open type: “ipconfig /release”
- After the message is displayed, type: “ipconfig /renew”
- You will see your new IP address and other connection settings displayed.
- Open the LAN Setup section. The wording for the section will vary depending on the router brand. Look for the Address Reservation section. Here you can assign permanent private IPs to specific devices. Create a new entry.
- Select the device from the list of connected devices. If you don’t see it, you will need to manually enter the device’s MAC address and name.
- Choose an IP address. Typically you can leave the first three sections of the address the same (usually 192.168.1). The last section is the number that you should change. On most routers you can enter any number between 1 and 100, although some let you go as high as 254.
- Make sure that the address you pick is not currently in use by another device on the network. This will cause a conflict, and one device will lose its connection.
- Windows 8 users can start typing “network and sharing center” while on the Start screen and select it from the list.
- Windows XP users can right-click on My Network Places in the Start menu and select Properties to see the list of their connections.
- To specify your IP address for IPv4, click Use the following IP address, and then, in the IP address, Subnet mask, and Default gateway boxes, type the IP address settings.
- To specify an IP address for IPv6, click Use the following IPv6 address, and then, in the IPv6 address, Subnet prefix length, and Default gateway boxes, type the IP address settings.
- A typical IPv4 address looks like 192.168.1.2; a typical subnet mask would be 255.255.255.0. The Default Gateway is generally the address of your router. For example, the numbers for our system are as follows:
- IP Address: 192.168.0.2 through 192.168.0.12 (for multiple computers)
- Subnet Mask: 255.255.255.0
- Default Gateway: 192.168.0.1